User Manual

AXELL MBF-40 AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc. No. 00071UM Rev. 3.2 67
• Remote units configured with an IP address and connected to the communication
infrastructure, can be queried directly.
To activate the MBF-40 SNMP Agent
1. Click on the Config button (top right corner) and select SNMP Agent Config. The
following pane appears:
2. Set the SNMP Agent toggle to ON.
3. Set the port and the Read-Only community.
4. Click Apply.
6.4 User Accounts
The MBF-40 comes pre-configured with default usernames and passwords in the various
administration levels.
At the moment, updating user accounts is available only via Command Line Interface
(CLI) or Axell Shell. See the Common Commands and Attributes v2.4.0 document for
detailed commands and syntax or click on the Help button at the top right of the Web-
GUI screen.
6.4.1 Default User Accounts
User Name Default Password Details
Axell
AxellPasswd
Default user name.
omcuname iwnkhoob
Axell Element
Manager (AEM) user account. This
account will not generate VLI, LGO or CLR alarms.
sysadmin AxellAdmin4050
This is the system administration password which is
used for firmware upgrades and user administration.
Escalation to this level is achieved by issuing
command SYSADMIN from the user prompt.
useradmin UseradminPwd23
This account contains user administration privileges.
Escalation to this level is achieved by issuing
command USERADMIN from the user prompt.
NOTE: It is strongly recommended to change the default user names and passwords immediately at
commissioning. This is done by using the command ACT PASSWORD. Please refer to the User
Administration section in Common Commands and Attributes document for detailed syntax.
6.4.2 User Access Levels
In this generation of the system, standard users can be promoted to login via the Web
Interface, inheriting the Read-Write or Read-Only access to this interface.