User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring, Fault Sourcing and Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF-40 AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc. No. 00071UM Rev. 3.2 59
Figure 5-3: Example of MBF-40 Tri-Band Configuration window
3. In the Downlink:
• Verify the Amplifier for each band is ON.
• Set Attenuation to maximum value (15dB).
• Lower the Attenuation level step by step until the desired Output power
level is reached (Zero attenuation = maximum gain).
• Verify the Amplifier Saturation is GREEN.
4. In the Uplink:
• Verify the Amplifier for each band is ON.
• Set Attenuation equal to the value set in the DL (above).
• Verify the Amplifier Saturation is GREEN.
NOTE: If noise is detected on the link, reduce only the Uplink for optimal signal.
Band
information
UL setting
DL setting