User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring, Fault Sourcing and Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
26 Doc. No. 00071UM Rev. 3.2 © Axell Wireless Ltd
3.3.3 Fan Hood and Bracket Assembly
WARNING!!
• This Fan Hood is to be assembled only on the MBF-40 units for which it is
designed and with which it is supplied.
• Do NOT assemble this fan hood on any repeater models for which it is not
specifically designed.
• Be sure to CAREFULLY follow all instructions – beginning with Step-1.
The fan hood and bracket assembly procedure is as follows:
• Assemble rear fan hood and mounting brackets
• Mount the repeater on the wall
• Assemble the front fan hood
• Connect power to both fan hoods
To assemble the fan hood
1. Place the repeater on a flat surface, repeater door panel facing down, interfaces
towards you.
2. Loosely assemble the mounting brackets:
• Align innermost bracket holes to repeater mounting holes.
• Loosely insert bolts and washers.
Figure 14: Place Brackets on top the MBF
Repeater front door
panel facing down
Align brackets and loosely
insert x4 bolts and washers