User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring, Fault Sourcing and Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF-40 AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc. No. 00071UM Rev. 3.2 23
3.3 Repeater with Fan Hood Installation
Some repeater models with power consumption exceeding 400W are supplied with a
fan-hood assembly kit. This section describes the bracket and fan assemblies for the
relevant repeater models.
WARNINGS!!!
• The fan modules can only be assembled on the appropriate repeater
models.
• This installation requires two people.
The following figure shows the assembled system. It includes the mounting brackets and
two fan assembly units. The dimensions, parts list and assembly instructions are
provided in the following sections.
Figure 3-12: MBF-40 including Fan Hood
2x Mounting
Brackets (one on
each side)
Rear Fan
Hood
Front Fan
Hood
Fan Hood Power
Interfaces (2)