User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring, Fault Sourcing and Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
20 Doc. No. 00071UM Rev. 3.2 © Axell Wireless Ltd
IMPORTANT!! Always check that there are no pipes or cables hidden in the wall
beneath the area to be drilled. Various pipe and cable detectors are available for this
type of inspection.
To mark and drill the wall
1. Mark out the fixing centres of the repeater on the chosen wall. Refer to the repeater
dimensions are shown below.
Figure 3-7: Fixing Centres
2. Mark and drill the wall with the correct size masonry bit as specified by the fixing
manufacturer.
NOTE: It is good practice to wear goggles to protect your eyes from flying debris when using
power tools.
3. Hold the drill bit against the mark and begin drilling slowly so that the bit does not
wander from the position. The wall should be drilled to a depth which is sufficient to
accommodate the full length of the fixing.
4. Insert the fixings so that the top of the sleeve/anchor section is level with the wall
surface.
368mm
378mm
Hole to take
M6 rawl bolt
Hole to take
M6 rawl bolt
189mm
189mm
Centre Line of MBF
Hole to take
M6 rawl bolt
Hole to take
M6 rawl bolt