User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring, Fault Sourcing and Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
10 Doc. No. 00071UM Rev. 3.2 © Axell Wireless Ltd
1.7.3.3 Dual Power Supply
The figure below provides an example of a unit with a dual power supply. The internal
view of your unit may differ.
Figure 1-11: Dual band Dual Service Antenna Model
1.7.3.4 MIMO Model
The MIMO model includes two Service Antenna ports and two Optic Converter modules
(shown below). All other connections and interfaces are similar to the above models.
Figure 1-12: MIMO Model
Dual Fiber
optic
connectors to which
routed optic Fiber
s are
connected (section 3.7)
F/O Converter LEDs and
optic connector to which
routed optic fiber is
connected (section 3.7)
Power connections
(section 3.9)
Controller module with
USB local setup
connections. Section
7.4.1 - LED descriptions
Rechargeable battery
pack, See 3.9.6
Two Power Supplies (and
battery switches). Section
3.9
Alarms and relay
connections. Section 3.8.