User Manual

MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd User Manual Doc No. 00068UM Rev. 2.4 VII
Caution: Safety to
equipment
When installing, replacing or using this product, observe all
safety precautions during handling and operation. Failure to
comply with the following general safety precautions and
with specific precautions described elsewhere in this manual
violates the safety standards of the design, manufacture, and
intended use of this product.
Changes or modifications not expressly approved by the
party responsible
for compliance could void the user’s
authority to operate the equipment.
Axell Wireless assumes no liability for the customer's failure
to comply with these precautions. This entire manual should
be read and understood before operating or maintaining the
repeater.
Warning: Restricted
Access Location
Access to the Axell unit installation location is restricted to
SERVICE PERSONNEL and to USERS who have been
instructed on the restrictions and the required precautions to
be taken.
Attention: Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device.
Static electricity can be conducted to the semiconductor chip
from the centre pin of the RF input connector, and through
the AC connector pins. When unpacking and otherwise
handling the repeater, follow ESD precautionary procedures
including use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
Caution: Class 1 Laser
The repeaters described in this manual are equipped with
class 1 lasers, as per definition in EN 60825-1
Caution - Un-terminated optical receptacles may emit laser
radiation. Exercise caution as follows:
• Do not stare into beam or view with optical instruments.
Optical transmitters in the fibre optic converter can send
out high energy invisible laser radiation. There is a risk
for permanent damage to the eye.
• Always use protective cover on all cables and connectors
which are not connected.
• Never look directly into a fibre cable or a connector.
• Consider that a fibre can carry transmission in both
directions.
• During handling of laser cables or connections, ensure
that the source is switched off.
Regard all open connectors with respect and direct them in a
safe direction and never towards a reflecting surface.
Reflected laser radiation should be regarded as equally
hazardous as direct radiation.