User Manual

MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
IV User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
FCC Part 20 Warning Statement
WARNING: This is NOT a CONSUMER device. It is designed for installation by FCC
LICENCEES and QUALIFIED INSTALLERS. You must have an FCC LICENCE or
express consent of an FCC Licensee to operate this device.
Unauthorized use may result in significant forfeiture penalties, including penalties in
excess of $100,000 for each continuing violation.
FCC Part 15
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
If not installed and used in accordance with the instructions, this equipment generates,
uses and can radiate radio frequency energy. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to RF reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Repeaters must be used ONLY for in-building applications
One must be aware that FCC regulation mandate that these repeaters are to be used
only for in-building applications and thus feed passive or active DAS (Distributed
Antenna Systems) accordingly.
Unauthorized Changes to Equipment
Changes or Modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment
FCC RF Exposure Limits
This unit complies with FCC RF exposure limits for an uncontrolled environment. This
equipment must be installed and operated with a minimum distance of 32 cm between
the radiator and any person’s body.
Antenna Installation
Installation of an antenna must comply with the FCC RF exposure requirements. The
antenna used for this transmitter must be mounted on an indoor permanent structure.
The maximum antenna gain for indoor operation is 13 dBi. Antennas having a gain
greater than these are strictly prohibited for use with this device. In indoor applications
the antenna must be installed at a minimum separation distance of 32 cm from all
nearby persons.