User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
28 User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
4. Connect the fibre to the Fibre Optic Converter
inside the repeater.
NOTE: Make sure the fibre is not bent too sharply inside
the repeater as to avoid communication disruptions.
5. Place the fibre in the rubber seal.
Note: The sleeve, together with the rubber seal, meets the
protection standard IP65.
6. Adjust the fibre length inside the repeater and
insert the seal into the fibre input interface.