User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
16 User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
3.2 Quad-Band Installation
The MBF-20 Quad-band consists of two assembled MBF-20 remotes: an MBF-20 Master
and an MBF-20 Expansion. The MBF-20 Quad-band unit is fed by a single F/O cable and
shares two service antennas, where the F/O and service antenna interfaces are located
on the MBF-20 Master unit. A dedicated power supply is installed for each unit.
If a Master MBF-20 is pre-installed, it is required to dismount the unit before assembling
it to the MBF-20 Expansion unit.
NOTE 1: The MBF-20 Quad-band Installation Sheet provides Instructions for assembling the Master
and Expansion unit and installing the assembly.
NOTE 2: For optimal VSWR performance on QUAD-band units, you can use an external two way
splitter (acquired free of charge) from you local Axel wireless sales representative.
Figure 3-6: Cascaded MBF-20 Quad-band