User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd User Manual Doc No. 00068UM Rev. 2.4 3
1.2 Interfaces
This section describes the interfaces for the MBF-20 Dual-band and MBF-20 Quad-band
remotes.
The image below shows the dual-band unit without the wallmount bracket or power
supply.
Figure 1-2: MBF-20 Dual-Band Front Panel
The image below shows the assembled quad-band unit without the wallmount bracket or
power-supplies.
Figure 1-3: MBF-20 Quad-Band Front Panel
Status LEDs
Power
Service
Antenna
Optic port
Service
Antenna
Press to initiate
setup (relevant
for future
versions)
Status LEDs
Service Antenna
Press to initiate
opto-adjustment (optional)
Power (Master)
Power (Slave)
Service Antenna
Fibre Optic port