User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
32 User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
5. Withdraw the “One Click” cleaner and replace the protective end cap.
6. Inspect the fibre connector using a Fibrescope. On the PC monitor, verify that there
is no contamination present on the connector end-face.
7. If the connector is dirty, clean it with a wet cleaning technique followed immediately
by dry cleaning. This is to remove any remaining residue from the wet clean (the
following steps demonstrate a wet cleaning technique).