User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd User Manual Doc No. 00068UM Rev. 2.4 27
Appendix B: Optic Fibre Cables
Connections
This product is equipped with Class 1 lasers, as per definition in EN 60825-1.
Caution!!! Un-terminated optical receptacles may emit laser radiation.
Do not stare into beam or view with optical instruments.
Note: Angled connectors, APC, need to be used throughout the whole link between the unit and the
remote. The angle needs to be 8 degrees. Also the ODF connections need to be APC type.
The fibre must be monomode type.
Connecting the Fibre Optic Cable
1. Select type of optic fibre (Recommended fibre
cable is single mode 9/125).
2. Run the fibre through a corrugated sleeve.
3. Insert the cable via the Fibre input.