User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd User Manual Doc No. 00068UM Rev. 2.4 15
3.1.8 MBF-20 Local Optical Link Adjustment (N/A)
NOTE: This option will be available in future versions.
To verify the link is operational, you can initiate Optical Link Adjustment (OLA) by
pressing a button at the side of the MBF-20.
To initiate OLA from the MBF-20 side
1. Locate the auto-config button at the side of the remote (see below).
2. Use a pin (or similar thin object) to press the sunken button.
3. Wait two minutes and verify LED Opto Tx and Opto Rx status.
3.1.9 What Next
After completing the physical installation, the MBF-20 is automatically detected by the
OMU II. The adjustment and setup procedure is then performed from the OMU II side
(Chapter 4).