User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
14 User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
3.1.6 Power Up
To power up
Connect the Remote P.S. to the AC power outlet and to the Remote DC connector.
Figure 3-4. Powering Up
3.1.7 Fibre Optic Connections
Note the following:
• Be sure to use low loss optic fibre cables
• Install according to F/O specifications and installation criteria are described in
Appendix B.
To connect the F/O cable from the OMU II side to the Remote
NOTE: Be sure to use low loss cables.
1.. Connect the F/O cable from the OMU II side to the Remote’s F/O port.
2. Verify F/O is securely connected.
3. Verify LEDs (see Appendix D).
Figure 3-5: MBF-20 Dual-Band Fibre Optic Connection
Fibre Optic Port
Connect to
Repeater Power
Connect to
110/230 VAC