User Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 MBF-20 Installation
- 4 MBF-20 Setup and Commissioning
- Appendix A: US/Canada Specifications
- Appendix B: Optic Fibre Cables Connections
- Appendix C: F/O Cleaning Procedure
- Appendix D: LED Troubleshooting
MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd User Manual Doc No. 00068UM Rev. 2.4 11
3.1.4 Mounting Remote
Choose the location of the Remote on the wall according to the following criteria:
• The location should be at normal eye level height, above ground.
• Be sure to allow easy access to the Remote for maintenance and on-site
inspection.
WARNING!!! The Remote must always be installed vertically and top-down, to allow free-flow of
cooling air. Horizontal installation on a bench for prolonged period of time may cause damage to the
Remote due to over-heating
To mount the Remote on the wall
1. Insert the supplied power supply tabs into the side of the bracket, each tab in its slot
and tighten using the provided screws.
2. Using the bracket assembly for reference to the bolt locations, insert the appropriate
bolts (not supplied) on the wall, according to the type of wall.
3. Hang the bracket assembly on the wall and tighten.
Figure 3-1. Mounting the Bracket on the Wall
4. Hang the Remote on the Bracket as illustrated below.
To do so, refer to Figure
3-2:
Insert PS
tabs here
Screw in
tabs here
Hang bracket on these