User Manual

MBF-20 AMERICAS REMOTE
PRODUCT DESCRIPTION AND USER’S MANUAL
6 User Manual Doc No. 00068UM Rev. 2.4 © Axell Wireless Ltd
2.1.3 RF Cable Installation Guidelines
Required:
• For all coaxial connections to/from the Repeater - high performance, flexible, low
loss 50Ω coaxial communications cable.
• All cables shall be weather-resistant type
.
• Cable length - determined by the Repeater installation plan. When calculating the
cable length, take into account excess cable slack so as not to limit the insertion
paths.
2.1.4 F/O Cable Installation Guidelines
Use the following over the complete link between the Remote and OMU:
• Use angled APC connectors at 8deg angle.
• APC type ODF connections.
• Cable length - determined by the Remote installation plan. When calculating the
cable length, take into account excess cable slack so as not to limit the insertion
paths.
Recommended fibre-optic cable:
• Single mode 9/125
2.2 Service Antenna Requirements (English)
This section provides information on the specifications of the service antennas suitable
for operation with this repeater, on the installation requirements of the antennas and on
the Repeater installation site and cable requirements.
ATTENTION!!
• The installer is held accountable for implementing the rules required for deployment.
• Good engineering practice must be used to avoid interference.
• Output power should be reduced to solve any IMD interference issues.
2.2.1 Required Antenna Information
The following antenna requirements, specifications and site considerations should be
met.
• Service area type and size
• Antenna type and characteristics
• Height
• Length and type of coaxial cable required for connecting the Service antenna to the
Remote and the attenuation.
2.2.2 Recommended Antennas
The Service antenna is installed indoors, where the type of antenna depends on the
application.