User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 54
5.5.2 Modifying Operation Mode
The Booster operation mode (Class A or Class B) is modified via the CMU Info tab.
NOTE: Class B supports
both
narrowband and wideband filters; Class A supports
only
narrowband filters.
To modify the Booster operation mode
1. In the left pane, select CMU and click the CMU Info tab.
2. In the Repeater Info area, the Supporting field shows the currently selected operation mode: Class A
or Class B.
Figure 5-17. Switching Class A/B Operation Mode
3. To change mode from Class A to Class B:
• In the Supporting field, select Class B. The following warning appears.
ATTENTION! Be sure to read and comply with the warning before changing the
repeater operation mode from Class A to Class B.
• Click Send in the pane header. The repeater will automatically perform a software reset.
Class A or Class B