User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 51
5.4.2 Embedded Software Upgrade
The procedure described in this section is used to upgrade the embedded software version.
To upgrade the embedded software version
1. Note the current software version build currently installed on the repeater, by clicking the
Band
item in
the left pane, and selecting the Band Info tab.
Figure 5-12. Band Info Tab Showing Currently Installed Build
2. Upload the file:
• From the left pane, click the
Band
and choose the SW Upgrade tab.
Figure 5-13. Upload Build File
Click Upload
File(s)
Browse for file
Build version