User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 45
5.2.2 Band Level General Parameters
Use the Band Info tab to perform the following operations:
• View identification information and build versions
• View valid filter bandwidth (depends on whether the Booster is operating in Class A or Class B mode)
• Allocate the number of filter for each Band
To access the Booster Information window
1. From the left pane, select the 700-800 item.
2. Select the Band Info tab. The relevant parameters are displayed.
Figure 5-4. Band Level Information
3. To change the number of channels allocated to each band (24 channels for both bands):
• Select the number of channels for the 700 band.
• The remaining available channels (for a total of 24) is allocated to the 800 band.
Supported bandwidth
Select 700 band
channels