User's Manual

SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 33
3. To define the filters:
• Click the Control&Params tab.
• Click the button corresponding to the required band: 700 or 800.
Figure 4-9. Sub-band Allocation Configuration
The displayed pane is relevant to the selected band. It is divided into three areas:
• System – overall parameters for the
selected service.
• Sub-band (filter) definitions area.
• Graphical view of defined sub-bands.
4. Configure the general System parameters as follows:
Figure 4-10. Control and Params Tab – Required System Parameters
• Verify RF Transmission Enable is checked (RF transmission ON).
NOTE: Under certain conditions related to the Shut Down mechanism, the RF transmission can be
disabled (unchecked) by the system. The Shut Down mechanism is described in the next step -
Optional System parameters).
• Set Max Composite DL Output Power – set according to your site requirements and click
Send. The
Measured Composite DL Output Power is displayed in the adjacent field.
NOTE: If the composite output power exceeds the defined value, the Smart-ALC feature begins
working (refer to section 1.4 for more information on SALC).
• Set Max Composite UL Output Power – set according to your site requirements and click
Send.
Global RF
parameters
Define filters
Graphical
view of
defined filters
Choose band
Set DL value
Enabled
Set UL value