User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 19
2. Once unit is held in the chosen position, carefully insert the fixing bolts through the mounting lugs of the
unit and into the sleeve/anchor sections of the fixing in the wall and tighten the bolts.
WARNING!
The unit needs to be mounted tightly to eliminate vibration.
Figure 3-11: Mount Repeater
3.3.2.5 Recommended Additional Fixing
SUGGESTED PRECAUTIONARY MEASURE!!
•
Brackets are provided to securely mount the unit on the wall; however, as an
additional
precautionary
measure, it is recommended to further secure the unit to the wall (in addition to the bracket).
•
This can be done using any appropriate method.
•
It is the installer’s responsibility to ensure the unit is installed in a secure manner.
The following figures provide
examples
of additional fixings. In the examples, support is provided in the form
of a CABLE HARNESS LOOP that is looped around the unit handle and secured to the wall or part of the
building support structure.
Figure 3-12: Example 1 of Additional Fixing to Wall
Align Repeater and
Secure Bolts