User's Manual

SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 13
3.3 Mounting the System
Note the following:
• The mounting procedure is identical for both indoor and outdoor installations.
• The weight of the
Booster requires that two people mount the unit on the wall.
• Washers are
not supplied with the unit to be mounted.
• In addition to the bracket assembly, it is recommended to use
additional fixings – an example is given in
section
3.3.2.5.
3.3.1 Rack Mount Installation
The supplied brackets are used to mount the repeater either on a wall or in a 19” rack. The same brackets
are used for both medium and high-power repeaters.
IMPORTANT!!
• The weight of the unit requires that two people mount the unit.
• The signal booster must always be installed vertically with the connectors on the
underside for protection.
Horizontal installation on a bench for long time may cause
damage to the signal booster due to over-heating.
To mount the unit in a rack
1. Use the x4 (provided) M8 Fixing Bolts
and X4 M8 Spring Washers and x4 M8
Flat Washers to assemble the brackets as
illustrated in the adjacent figure.
Figure 3-2: Rack-mount bracket position