User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 23-Nov-16
www.cobham.com/wireless
Doc. No.00060CDUM Rev. 3.4 Page | 11
3 BOOSTER MOUNTING AND INSTALLATION
This chapter describes the booster installation.
NOTE: If included in the installation, the Battery Charger is installed adjacent to the Booster. Refer to the
Battery Charger manual for instructions on installing the Battery Charger.
WARNINGS!!!
• Follow all local safety regulations when installing the Signal Booster.
• Only qualified personnel are authorized to install and maintain the Signal Booster.
• Follow Electro-Static Discharge (ESD) precautions.
3.1 Booster Installation Overview
The Booster installation procedure consists of the following steps.
Figure 3-1 Physical Installation Workflow
Step-1
• Unpacking
Step-2
• Mounting
Step-3
• Grounding
Step-4
• Antenna connections
Step-5
• Power Connections
Step-6
• Alarm connections