User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 57
6.3.2 CMU Alarms Screen - Activated Alarms
The CMU Alarms screen shows any activated Alarms, including any activated dry-contact alarms.
To view activated alarms
Click on CMU in the left pane and select the CMU Alarms tab. The following screen appears.
Figure 6-5. CMU Info Tab Showing Activated Alarms
6.3.3 Alarms Log
The CMU maintains log files listing every alarm triggered in the Booster. These are displayed in the Alarms
Log screen. This screen provides an analysis tool to get information of any event that has occurred, its
originator, when, if they return, and their type.
NOTE: Time of occurrence of the events is set according to the Booster clock ( 4.4).
To view the CMU log screen:
Click on CMU in the left pane and select the Alarms Log tab. The following screen appears.
Figure 6-6. CMU Log Screen
Item Description
Time Stamp The date and time the alarm was created
Source ID of Network Element
Description Description of event that caused the alarm