User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 49
5.4.1 CMU Software Upgrade
The procedure described in this section is used to upgrade the repeater CCD.
NOTE: This procedure is performed for every new management version.
The CMU SW upgrade procedure consists of loading the new software version and installing it in the CMU.
The CMU can store two versions on two separate data banks enabling restore to a previous version.
To Upgrade the CMU SW
1. If necessary, note the
currently
loaded CMU SW Version and OS Version by clicking the CMU option
in the left pane and selecting the Axell CMU Info tab.
Figure 5-10. CMU-Info Tab Showing Currently Installed Versions
2. Click the CMU SW Upgrade tab. The Software Upgrade screen appears.
Figure 5-11. Select File for Uploading
a. Browse for the
new file
b. Select the Bank for
storing the file
c. Click
Upload
CMU SW
Version and
OS Version
CMU Info Tab