User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 38
4.6 IP Address and SNMP Notifications
This section describes how to set up the booster’s IP Address and SNMP notifications management
To configure the IP Address and SNMP Notifications
1. Click on CMU in the left pane and select the Communication Configuration tab. The following screen
appears.
Figure 4-15. Communication Configuration Dialog
The following areas are relevant to this Booster installation.
Area Description
IP Configuration Used to define Static IP Address and DHCP Address.
SNMP Trap
options
This includes enabling SNMP Trap options and defining the relevant
parameters.
SNMP notifications
Click CMU
Click
Communication
SNMP Trap
Config
IP Address
config