User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 12
3 BOOSTER MOUNTING AND INSTALLATION
This chapter describes the booster installation.
Note the following:
• It is assumed the location of the booster has been selected according to the criteria listed in section 2.4.
• If included in the installation, the Battery Charger is installed adjacent to the Booster. Refer to the
Battery Charger manual for instructions on installing the Battery Charger.
WARNINGS!!!
• Follow all local safety regulations when installing the Signal Booster.
• Only qualified personnel are authorized to install and maintain the Signal Booster.
• Follow Electro-Static Discharge (ESD) precautions.
3.1 Booster Installation Overview
Figure 3-1 Physical Installation Workflow
Step-1
• Unpacking
Step-2
• Wallmounting or Rack Mounting
Step-3
• Connections: GND, Antenna,
Dry-contact alarms
Step-4
• Power Connections: UPS or Battery Charger
Step-5
• Power ON