User's Manual

SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 33
3. To define the filters:
• Click the Control&Params tab.
• Click the button corresponding to the required band: 700 or 800.
Figure 4-9. Sub-band Allocation Configuration
The displayed pane is relevant to the selected band. It is divided into three areas:
• System – overall parameters for the
selected service.
• Filter definitions area.
• Graphical view of defined filters
4. Configure the general System parameters as follows:
Figure 4-10. Control and Params Tab – Required System Parameters
• Verify RF Transmission Enable is checked (RF transmission ON).
NOTE: Under certain conditions related to the Shut Down mechanism, the RF transmission can be
disabled (unchecked) by the system. The Shut Down mechanism is described in the next step -
Optional System parameters).
• Set Max Composite DL Output Power – set according to your site requirements and click
Send. The
Measured Composite DL Output Power is displayed in the adjacent field.
NOTE: If the composite output power exceeds the defined value, the Smart-ALC feature begins
working (refer to section 1.4 for more information on SALC).
• Set Max Composite UL Output Power – set according to your site requirements and click
Send.
General RF
parameters
Define filters
Graphical view
of
defined filters
Choose band
(for dual band)
Set DL value
Enabled
Set UL value