User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 32
4.3 RF Parameters and Filter Configuration
A total of 24 filters can be defined for each unit. For D-MBR 700 800 (a booster supporting two bands):
• The total of 24 filters is distributed between the two bands.
• The number of filters available for each band can be configured in the Band Info tab.
To configure the signal level and channels
1. In the left pane, click the 700/800 item.
2. For dual-band boosters, verify the number of channels allocated to each band:
• Click the Band Info tab. The available filters are displayed in the Band Information area.
Figure 4-8. Configuring Number of Filters per Band
• In the Channels for 700 band, select the number of filters for the 700 band. The
remaining available filters will be allocated to the 800 band.
• Click Send in the header.
No of
channels
per band
Click Send Band Info
Channel width