User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 22
3.4.2 Antenna Connections
CAUTION!!
• Do not connect the antenna cables to the Signal Booster before verifying the installation parameters -
specifically the isolation between the antennas.
• DO NOT POWER-ON the Signal Booster without either the antennas being connected or the antenna
connections terminated with dummy loads.
To connect the antennas
• Connect the Donor and Service antennas.
• Verify all RF connectors are tightened and the cables and antennas are secured.
Figure 3-15 Booster GND Lug
Donor antenna
Service antenna