User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 16
3.3.2.2 Wall Marking and Drilling – General Instructions
WARNINGS!!
• Due to the weight of the unit, it is NOT recommended to fix to a hollow wall.
• Always check that there are no pipes or cables hidden in the wall beneath the
area to be drilled. Various pipe and cable detectors are available for this type of
inspection.
Note the following:
• The Repeater wall mount brackets assembly should be fixed to a solid wall (these include brickwork,
block work, and concrete).
• To provide secure fixing to a solid wall, the most common method is drilling and plugging. The size of
fixing is dependent on the item to be fixed and the nature of the wall, The Repeater should be fixed with
mild steel, M6 (50mm to 75mm) rawlbolts or similar.
The following items are provided in the kit:
• X4 BOLT ANCHOR JUMBO 3/8 ZINC PLATED
• X4 FLAT WASHERs # 3/8
• X4 SPRING WASHERS # 3/8
• NUTGND HEX #3/8
Figure 3-5: M6 Rawlbolt – recommended for wallmount.
• Care must be taken to ensure the alignment of the four fixings. A spirit level or plumb line should be
used to ensure horizontal/vertical alignment.