User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 BOOSTER PRE-INSTALLATION REQUIREMENTS AND GUIDELINES
- 3 BOOSTER MOUNTING AND INSTALLATION
- 3.1 Booster Installation Overview
- 3.2 Unpacking and Package Contents
- 3.3 Mounting the System
- 3.4 Connections
- 4 SETUP AND COMMISSIONING
- 5 ADMINISTRATIVE OPERATIONS
- 6 MONITORING AND TROUBLESHOOTING
SMR 700 800 HIGH POWER PS NFPA CLASS A SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 22-Dec-16
www.cobham.com/wireless
Doc. No.00068CDUM Rev. 2.3 Page | 15
2. Mount the unit
vertically
in the rack, while
adhering to standard rack mounting
procedures, and secure.
Figure
3-3: Rack-mount unit position
3.3.2 Wallmount Installation
IMPORTANT!!
• The unit mounting procedure is for concrete or brick walls only.
Verify the
suitability of the wall on which the unit is to be to be fitted.
• The weight of the unit requires that two people mount the unit on the wall.
• The signal booster must always be installed vertically with the connectors on
the underside for protection.
Horizontal installation on a bench for long time
may cause damage to the signal booster due to over-heating.
3.3.2.1 Wallmount Bracket Assembly
NOTE: In addition to the mounting brackets, it is recommended to use additional fixings as described in
section 3.3.2.5.
Assemble the brackets to the unit using the supplied M8 Fixing Bolts and X4 M8 Spring Washers and
x4 M8 Flat Washers to assemble the brackets as shown in the following figure.
Figure 3-4. Bracket Assembly for Wall-mount
M8 Fixing Bolts,
Spring Washers and
Flat Washers
M8 Fixing Bolts
,
Spring Washers and
Flat Washers