User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd
Doc PN 00038UMCD Rev. 1.6 VII
Caution: Safety to personnel.
Before installing or replacing any of the equipment, the entire
manual should be read and understood.
The user needs to supply the appropriate AC or DC power to the
repeater. Incorrect power settings can damage the repeater and
may cause injury to the user.
Please be aware that the equipment may, during certain
conditions become very warm and can cause minor injuries if
handled without any protection, such as gloves
Caution: Safety to equipment
When installing, replacing or using this product, observe all safety
precautions during handling and operation. Failure to comply with
the following general safety precautions and with specific
precautions described elsewhere in this manual violates the safety
standards of the design, manufacture, and intended use of this
product.
Axell Wireless assumes no liability for the customer's failure to
comply with these precautions. This entire manual should be read
and understood before operating or maintaining the repeater.
Warning: Restricted Access
Location
Access to the Axell unit installation location is restricted to
SERVICE PERSONNEL and to USERS who have been instructed
on the restrictions and the required precautions to be taken.
Attention: Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device.
Semiconductor transmitters and receivers provide highly reliable
performance when operated in conformity with their intended
design. However, a semiconductor may be damaged by an
electrostatic discharge inadvertently imposed by careless
handling.
Static electricity can be conducted to the semiconductor chip from
the centre pin of the RF input connector, and through the AC
connector pins. When unpacking and otherwise handling the
repeater, follow ESD precautionary procedures including use of
grounded wrist straps, grounded workbench surfaces, and
grounded floor mats.
Caution: Battery
Replacement
Risk of explosion if battery is replaced with incorrect type. Dispose
of used batteries according to instructions.