User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd
Doc PN 00038UMCD Rev. 1.6 43
Appendix A: Specifications (@+25°C)
Electrical
Parameter Downlink Uplink
Frequency Range (GSM) 935-940MHz 896-901MHz
Passband Gain 90 dB
Passband Ripple ± 2 dB ± 2 dB
Gain Attenuation Range 0-25 dB (in 1 dB steps)
Composite Output Power +37dBm +23dBm
Number of Filters (*) 1 to 8
Noise Figure @ Maximum Gain
(typical)
5 dB
Propagation Delay 6 µsec
General
Power Supply 110VAC, 350W
Total RF Input Power (No Damage) + 10 dBm
Impedance Level 50 Ohm
RF Connector N-Type, Female
V.S.W.R 1.5:1
Environmental
Operating temperature -4 to +122°F (-20 to +50°C)
Storage temperature -22 to +158°F (-30 to +70°C)
Dimensions W x H x D 540 x 382 x 313 mm
Weight 33kg
Enclosure IP-65, NEMA 4
Conformance Standard FCC
(*) Supports any BW option 200 KHz - 5MHz by setting the start-stop frequency