User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd
Doc PN 00038UMCD Rev. 1.6 37
5.4.2 Restoring Previous Repeater Configuration
To restore previous configuration
1. Select the required configuration file (enable corresponding radio button) from the
available list in the Backup/Restore tab.
2. Click the Restore button.
Note: The following figure is only an example of the Backup/Restore tab.
3. Click on the Control and Params tab and verify that the required configuration
settings have been restored.
5.4.3 Uploading New Configuration File to Repeater
To upload configuration file to Repeater
1. Click the Upload button.
Note: The following figures are oly an example of the Backup/Restore tab.
2. Select the file from the Browse dialog and click Open.
3. The file appears in the list displayed in the Backup/Restore table.
5.4.4 Saving Configuration File to Computer
To save a configuration file from the available list in the Backup/Restore table to a
location in a connected computer:
• Select file from list.
• Click the link in the File column.
• Select the location in the Browse dialog.