User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
26 Doc PN 00038UMCD Rev. 1.6 © Axell Wireless Ltd
• UL Gain Δ - used for noise control. Sets the difference between UL and DL
gain.
• UL Measured Ch. Gain - measured UL Gain (dB) for the selected sub-
band.
7. Click Send (top window area option).
8. After the channels have been configured and the required coverage is attained for
the location, verify that no Alarms are generated:
• Click the Alarms tab
• Verify that all the indicators are GREEN in the Alarms tab.
4.3.3 Setting Date and Time
It is important to set the correct date and time on the unit since this provides the
timestamp for each logged event and alarm.
To set the Repeaters date and time
1. Click on CMU in the tree pane, click on Date & Time in the menu bar.
2. Set the date and time parameters and click on Set.
3. Click Reset CMU at the top of the Main window.