User's Manual

Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
24 Doc PN 00038UMCD Rev. 1.6 © Axell Wireless Ltd
4.3.2 Adjusting the Signal Levels and Configuring Channels
The Control and Params (parameters) window is used to configure each of the
supported band's sub-bands and Max UL/DL Power. This section describes each of the
fields.
Each sub-band is individually defined by setting the following:
• Bandwidth (start and stop frequency)
• Maximum power
• Maximum gain
• Gain delta (used for noise control)
The defined sub-bands are displayed in the lower part of the screen for reference.
To adjust the signal levels and configure the channels
Note: Be sure to click Send with each change.
1. In the topology tree, click Root, then click CMU and then click the repeater Band.
2. Click the Control and Params tab. The corresponding pane appears.
The window is divided into the following areas:
• System – overall parameters for the service.
• Sub-band (filter) definitions – used to define up to eight sub-bands and
their RF parameters.
• Sub-bands view – graphical display of defined sub-bands for the service.
3. Set the System Level parameters:
• Verify that the RF Transmission Enable parameter is checked.
• Set the Max Composite DL Output Power according to your site
requirements and click Send. The Measured Composite DL Output Power is
displayed in the adjacent field.
System
level
parameters
Click Send with
each change
Sub-band definition
options
Defined
band channels