User's Manual

Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc PN 00038UMCD Rev. 1.6 17
4
4
I
I
n
n
i
i
t
t
i
i
a
a
l
l
S
S
e
e
t
t
u
u
p
p
a
a
n
n
d
d
C
C
o
o
m
m
m
m
i
i
s
s
s
s
i
i
o
o
n
n
i
i
n
n
g
g
This section provides the setup procedures for the D-SBR Repeater. The Repeater is
designed for simple plug-and-play operation, only requiring the setup of a number of
parameters (such as DL Output Power, bandwidth and Gain) via a local Web connection
and verifying that the system is operating properly.
The procedures are performed through an Ethernet connection between the Axell D-SBR
repeater and a computer.
The setup procedure consists of the following steps:
1. Open a local Web session to the Repeater (this requires configuring the
communication parameters of the computer used), see 4.1.
If you are not familiar with the Axell Web Access application, it is recommended to
quickly review the Navigating the Web GUI Application section (see
4.2).
2. Adjust the signal levels and configuring the sub-bands (see 4.3).
3. After the required coverage is attained for the location, verify that no Alarms are
generated before connecting to the main control center.
4. Set the Repeater time and date (see 4.3.3).
5. If external alarms are connected - configure the external alarms (see 4.4).