User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
10 Doc PN 00038UMCD Rev. 1.6 © Axell Wireless Ltd
3
3
.
.
4
4
M
M
o
o
u
u
n
n
t
t
i
i
n
n
g
g
t
t
h
h
e
e
R
R
e
e
p
p
e
e
a
a
t
t
e
e
r
r
Notes: 1. The weight of the unit requires that two people mount the unit on the wall.
2. Washers are not supplied with the repeater.
Mounting the D-SBR Repeater consists of assembling the brackets on the repeater and
then mounting the unit on to the wall.
To mount the Repeater on the wall
IMPORTANT!! The D-SBR repeater mounting procedure is for concrete or brick walls only.
1. Determine the location of the Repeater on the wall according section 2.3.3.
2. Assemble the brackets to the D-SBR Repeater using the supplied 4 x M4 bolts as
shown in the following figure.
Support Bracket x 2
Bracket-to-Repeater
mounting holes
x 2 per bracket