User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Specifications and Installation
- 3 Installing the Repeater
- 3.1 Overview of the Installation Procedure
- 3.2 Required Tools and Materials
- 3.3 Unpacking
- 3.4 Mounting the Repeater
- 3.5 Grounding
- 3.6 Verifying Isolation between Donor and Mobile Antennas
- 3.7 Verifying the Link between the BTS and the Repeater
- 3.8 Antenna Connections
- 3.9 Powering Up the Repeater
- 3.10 External Alarm Connections
- 4 Initial Setup and Commissioning
- 5 Administrative Operations
- 6 Monitoring and Troubleshooting
- Appendix A: Specifications (@+25°C)
Axell D-SBR 3709S Repeater
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd
Doc PN 00038UMCD Rev. 1.6 9
3
3
.
.
3
3
U
U
n
n
p
p
a
a
c
c
k
k
i
i
n
n
g
g
Upon receiving the D-SBR Repeater perform the following:
1. Examine the shipping container for damage before unpacking the unit.
2. Perform a visual inspection to reveal any physical damage to the equipment.
3. Verify that all of the equipment (listed below) is included. Otherwise contact Axell
Wireless Ltd. The D-SBR Repeater is shipped with the following equipment:
D-SBR single-band
Repeater
Ethernet RJ-45 LAN cable
Ext. Alarms Cable (P/N
40WEC70500)
CD with documentations
Mounting Brackets
Additional (supplied)
installation components:
Qty. Description
4x M4 bolts for mounting brackets to wall (concrete
or brick only)
4x M6 screws for
securing the Repeater to the
brackets
1x 110VAC Power Cable
2 x Sets of keys
Optional equipment
AC Cable [30 ft.] – Long cable for AC power
Alarm Cable [30 ft.] – Long cable for External Alarms
Input