User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
80 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
1900 MHz
Downlink
Uplink
Frequency Range
1930-1990 MHz
1850 – 1910 MHz
No. of Filters per Band*
Up to 6
Up to 6
Passband Max.Gain
73 dB
73 dB
Passband Ripple
±2.5 dB
±2.5 dB
Gain Attenuation Range
0 to 25 dB (in 1 dB steps)
0 to 25 dB (in 1 dB steps)
Composite Output Power
20dBm**
20dBm**
Noise Figure@ Maximum
Gain (typical)
6 dB
6 dB
Propagation Delay
6 µsec
6 µsec
(*) Supports every BW option 200KHz-25MHz by setting the Stop-Start frequency. Total numbers of filters is 6 per dual-
band. See section 5.2.5 for details.
(**) 3.5dB less in tri/quad band configurations due to combining loss.
Electrical
Parameter
Value
Power Supply
100 - 240 VAC, 150W (typical)
Power Consumption
< 70Watt for dual-band, < 45Watt for single band
Mechanical Specifications
Parameter Value
Dimensions (b x h x d) 299 x 305 x 77 mm (11.7 x 12 x 3.03 inch)
Installation Wall Mount
Weight 8.9 lbs for dual-band
Environmental Specifications
Condition Value
Operating Temperature
Range
0 °C to +50 °C (32° to 122° F)
Humidity 85%, ETS 300 019-1-3 Class 3.1
Ingress Protection IP41
MTBF, Complete System >70,000 hrs.