User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
70 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
6.8 DMCU Administration
6.8.1 Viewing Repeater Level Information
Use the CMU-Info screen to view the hardware and software versions of the DIGImini Repeater. In
addition, the screen provides configuration options for setting the minimum Log Level and assigning
the Repeater a recognizable name.
NOTE: Read-only or irrelevant parameters are grayed out.
NOTE: Usually, these fields are grayed-out. Grayed-out fields indicate that the display is Read-only.
Active fields indicate that the parameter values can be defined.
To access the Repeater Information window
1. From the Tree Pane, CMU and choose the Axell-CMU Info tab.
NOTE: The Axell-CMU Name field can be used to assign the module a recognizable name
corresponding to the technology.