User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 65
6. After a few minutes, a Modem IP Address should appear on the CMU GUI screen. This indicates
the modem is functioning on the CDMA Network. If the modem does not respond properly,
troubleshoot the modem via the Direct Access tab described in section
6.7.6).
6.7.5.2 Configuring Modem Communication Parameters
To configure the CDMA VERIZON modem communication parameters
NOTE: For other operators, consult with your Axell Wireless customer support.
1. In the left pane, click CMU and choose the Axell CMU Configuration tab.
2. In the Modem area, define the parameters as follows:
• Modem Communication = Always On
• The Remote Phone Number = #777
• Connection Init String = AT
• User Name = 1234567890@vzw3
• Enterprise ID parameter = VZW
3. In the SNMP Trap Configuration field area, enter the system identification name