User's Manual

AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
64 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
6.7.5 CDMA Modem Setup
NOTE: This procedure describes how to configure the CDMA modem for operation in a Verizon
network. For operation in other network, consult your Axell Wireless service personnel for
instructions.
This procedure for Verizon network setup consists of the following phases:
• Modem Activation and verification – via the Modem Direct Access tab
• Configuring Modem communication parameters – via the Communication Configuration tab
• If the modem does not respond properly, troubleshoot the modem via the Direct Access tab
described in section 6.7.6).
6.7.5.1 Activating Modem on the CDMA Network
For the modem to connect over a CDMA network, it must first be activated according to the
following procedure:
To activate modem CDMA functionality
1. Click CMU in the left tree pane and select the Modem Direct Access tab.
2. Click on the Modem Direct Access button. The Command to send text-box and Send button will
be available for entering commands.
3. Perform the following command sequence:
• Type the command ATD*22899; (including the semicolon) and click Send.
• Wait 10 seconds and then type the command AT and click Send. The following set of
responses should appear in the Modem Response area:
+WOT1: “Programming in Progress”
+WOTS: “SPL unlocked”
+WOTP: “PRL download OK”
+WOTM: “MDM download OK”
+WOTC: “Commit successful”
+WOT2: “Programming Successful!”
4. If “Programming Successful!” does not appear, verify RSSI and modem registration according to
the procedures in section
6.7.6.
5. Click on the Normal Mode button or on CMU Reset in the command bar for changes to take
effect.
ATD*22899;
Click Modem
Direct Access
Click Send
after
each command
Enter command