User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 63
6.7.4 GSM/GPRS Modem Setup
NOTE: It is assumed that the SIM card is already installed according to section
6.4.3. If the modem
does not respond properly, troubleshoot the modem via the Direct Access tab described in section
6.7.6).
This GSM/GPRS Modem setup consists of configuring the Modem communication parameters via
the Communication Configuration tab.
To define the GSM/GPRS modem Communication parameters
1. Click CMU in the left tree pane and select the Communication Configuration pane.
2. In the Modem area, select the Communication mode as Always On and define any additional
parameters according to the table below. (Any defined fields in the figure below are only an
example!)
3. If the modem does not run, troubleshoot using the Modem Direct Access Tab (section 6.7.6).