User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 59
6.6.3 Configuring the External Alarms
Any connected alarms (section 6.4.5) must be enabled and configured according to the instructions
provided in this section.
To configure external alarms
1. Click on CMU in the tree pane.
2. Click the External Alarms tab. The following dialog appears.
3. For each connected alarm:
• Checkmark the Active checkbox.
• Set the alarm Normal Mode as High or Low.
• In the Description field, assign the alarm an identifiable name.