User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 49
6.4.3 SIM Card Installation (GSM/GPRS Modems only)
WARNING!!! BE SURE TO INSERT THE SIM CARD BEFORE
CONNECTING THE DMCU TO THE REPEATER.
Press the protrusion (yellow button), shown in the
Figure 6-3 below, CONTINUOUSLY until the SIM tray extracts. You may need to use a small sharp
object (do not use a pencil).
Note: This section is not relevant to CDMA modem equipped units. See
6.7.5 CDMA Modem .
Figure 6-3. Insert SIM card
Press to extract SIM tray
and insert SIM card.