User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
48 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
6.3 DMCU Kit
The following items are provided in the DMCU kit:
DIGImini Controller Kit - Optional
DMCU
RS485 (9 pin) to RS485 9-pin
cable
CBL RS485 NO-
X 1.8M MALE/FEMALE GRY
(1579909492)
Controller Modem to Repeater
modem antenna cable
CBL ASSY SMA MALE X2 STR SHLD 1.8M
(CC010B0BA8)
6.4 DMCU Installation Procedure
The DMCU installation procedure slightly varies depending on whether it is a GPRS/GSM or CDMA
modem.
6.4.1 GPRS Modem
1. Insert the SIM card in the side panel slot.
WARNING! This must be performed before connecting the DMCU to the Repeater.
2. Connect the modem to the Repeater.
3. Optional – you may also wire the DMCU dry-contacts.
4. Configure the communication parameters.
6.4.2 CDMA Modem
1. Connect the modem to the Repeater.
2. Optional – you may also wire the DMCU dry-contacts.
3. Activate the Modem (via the Web GUI Direct Modem Access tab).
4. Configure the communication parameters.