User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 47
6.1 Features and Capabilities
• Provides complete remote control and monitoring capabilities over GPRS or CDMA, including:
• Remote control via SMS
• Remote alarming through SNMP alarm traps
• Ethernet port for local setup or remote management
• Single unit can support a DIGImini Quad-band installation (two Repeaters)
• No power required – acquires power from repeater
• Dry contact alarms – two external alarms and one summary alarm
• Compact and simple to install
6.2 DMCU Interfaces
Figure
6-2: DMCU Interfaces
Interface Description
Ethernet Ethernet Web session connection for setup.
CTRL Connect to DIGImini Repeater CTRL connector on the side panel.
Modem Connects to the Repeater ANTENNA connector on the Repeater side panel.
Dry Contacts Dry contact connector. See section 6.4.5
SIM
(GPRS only)
SIM Card Slot - Applicable only to GSM/GPRS models.
LEDs Band specific – service status
MNG – unit operation status
MDM – modem status
Ethernet
CTRL to DIGImini
Modem to DIGImini
Dry Contacts
SIM
(GPRS Only)
LEDs